Difference between revisions of "02426"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) (New page: __FORCETOC__ == 02426 - Brake Disk Left Rear; Not Reached == ==== Possible Symptoms ==== * Malfunction Indicator Lamp (MIL) active * Function Limitation ==== Possible Causes ==== * Th...) |
RtWiKiSyS0p (talk | contribs) m |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 9: | Line 9: | ||
==== Possible Causes ==== | ==== Possible Causes ==== | ||
| − | * | + | * Left Parking Brake Motor (V282) Power Supply faulty |
| + | * Left Parking Brake Motor (V282) faulty | ||
==== Possible Solutions ==== | ==== Possible Solutions ==== | ||
* Clear Fault Codes | * Clear Fault Codes | ||
| − | * Replace Left Parking Brake Motor (V282) | + | * Check Left Parking Brake Motor (V282) Power Supply |
| + | ** Connect Battery Charger | ||
| + | * Check/Replace Left Parking Brake Motor (V282) | ||
| + | ** Check Shut-Off Current, See Measuring Value Block (MVB) 003.1 & 003.2 | ||
| + | |||
| + | ==== Special Notes ==== | ||
| + | |||
| + | * This Fault will be set if the Parking Brake Motor runs for 20 Seconds while the Shut-Off Current isn't reached and the Wheel can still be turned. A possible Scenario would be operating the Parking Brake without a Brake Disc being installed/present, i.e. no End Position is being defined and may result in Damage to the Parking Brake Motor. | ||
| + | * Make sure to cycle the Parking Brake a couple of times between checking for Fault Codes, this will ensure that the Control Module tests the related Components again. | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 10:31, 19 August 2008
02426 - Brake Disk Left Rear; Not Reached
Possible Symptoms
- Malfunction Indicator Lamp (MIL) active
- Function Limitation
Possible Causes
- Left Parking Brake Motor (V282) Power Supply faulty
- Left Parking Brake Motor (V282) faulty
Possible Solutions
- Clear Fault Codes
- Check Left Parking Brake Motor (V282) Power Supply
- Connect Battery Charger
- Check/Replace Left Parking Brake Motor (V282)
- Check Shut-Off Current, See Measuring Value Block (MVB) 003.1 & 003.2
Special Notes
- This Fault will be set if the Parking Brake Motor runs for 20 Seconds while the Shut-Off Current isn't reached and the Wheel can still be turned. A possible Scenario would be operating the Parking Brake without a Brake Disc being installed/present, i.e. no End Position is being defined and may result in Damage to the Parking Brake Motor.
- Make sure to cycle the Parking Brake a couple of times between checking for Fault Codes, this will ensure that the Control Module tests the related Components again.