|
|
| (20 intermediate revisions by 3 users not shown) |
| Line 1: |
Line 1: |
| | __FORCETOC__ | | __FORCETOC__ |
| − | '''This procedure details how to replace a battery in a vehicle using a separate battery management control module. See the separate instructions for models where the battery management control module is a slave/subsystem of the gateway.'''
| |
| | | | |
| − | ''The following procedure does assume you are using a battery supplied by VW/Audi, all necessary details for the following steps can found on the battery itself. Make sure to refer to the factory repair manual in order to fulfill all additional prerequisites.''
| + | The information that was on this page moved to the [[Battery Replacement]] page. |
| − | | |
| − | '''[Select]'''<br>
| |
| − | '''[61 - Battery Regulation]'''<br>
| |
| − | '''[Coding - 07]'''<br>
| |
| − | '''[Battery Coding Assistant]'''<br>
| |
| − | * Enter the new Battery Part Number (10 or 11 digits).
| |
| − | * Enter the new Battery Serial Number (10 digits).
| |
| − | * Select the new Battery Vendor.
| |
| − | '''[OK]'''<br>
| |
| − | '''[Do it!]'''<br>
| |
| − | '''[Close Controller, Go Back - 06]'''<br>
| |
| − | | |
| − | Your new Battery should now be coded and the Battery Control Module should be aware of the new Battery.
| |
Latest revision as of 13:57, 10 May 2016