|
|
| (5 intermediate revisions by 3 users not shown) |
| Line 1: |
Line 1: |
| | __FORCETOC__ | | __FORCETOC__ |
| − | | + | The information that was on this page moved to the [[Battery Replacement]] page. |
| − | '''General Information:''' Most 2009+ Audi A4 and newer models do NOT use a separate 61-Battery Manager. In these cases battery management is a slave (subsystem) under the 19-CAN-Gateway control module. This page covers those 8T/8K/8R and newer models using a CAN Protocol 19-CAN-Gateway control module.<br>
| |
| − | <br>
| |
| − | If the vehicle in question uses a diagnostic capable 61-Battery Regulation controller this page ''should'' apply instead:
| |
| − | * [[Audi A8 (4E) Battery Replacement|61-Battery Regulation]]<br>
| |
| − | <br>
| |
| − | ----
| |
| − | | |
| − | === Long Adaptation ===
| |
| − | | |
| − | Installation of a new battery requires the use of the [http://www.ross-tech.com/vcds/tour/adaptation_screen.html#long Long Adaptation] function under 19-CAN-Gateway control module. Follow the onscreen instructions to enter the Part Number, Vendor, and Serial Number all as one long new value.
| |
| − | | |
| − | | |
| − | === Special Notes ===
| |
| − | | |
| − | | |
| − | | |
| − | | |
| − | | |
| − | [[Category:Subsystems]]
| |
Latest revision as of 13:56, 10 May 2016