Difference between revisions of "00515"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) m |
RtWiKiSyS0p (talk | contribs) m |
||
| Line 25: | Line 25: | ||
* Wiring to Camshaft Position (Hall) Sensor (G40) faulty | * Wiring to Camshaft Position (Hall) Sensor (G40) faulty | ||
| + | * Camshaft Position (Hall) Sensor (G40) Installation faulty | ||
| + | * Camshaft Timing Out of Specification | ||
* Camshaft Position (Hall) Sensor (G40) faulty | * Camshaft Position (Hall) Sensor (G40) faulty | ||
Revision as of 09:44, 21 November 2006
00515 - Camshaft Position (Hall) Sensor (G40)
00515 - Camshaft Position (Hall) Sensor (G40): No Signal
Possible Causes
- Wiring to Camshaft Position (Hall) Sensor (G40) faulty
- Camshaft Position (Hall) Sensor (G40) faulty
Possible Solutions
- Check Wiring to Camshaft Position (Hall) Sensor (G40)
- Check/Replace Camshaft Position (Hall) Sensor (G40)
- Check/Replace Engine Control Module
Special Notes
- Some older engines store this code as long as the engine is not running, if in doubt read fault codes with the engine running again.
00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to B+
Possible Causes
- Wiring to Camshaft Position (Hall) Sensor (G40) faulty
- Camshaft Position (Hall) Sensor (G40) Installation faulty
- Camshaft Timing Out of Specification
- Camshaft Position (Hall) Sensor (G40) faulty
Possible Solutions
- Check Wiring to Camshaft Position (Hall) Sensor (G40)
- Check/Replace Camshaft Position (Hall) Sensor (G40)
- Check/Replace Engine Control Module