Readiness - APB Engine Code: Difference between revisions

From Ross-Tech Wiki

Table Of Contents

← Older editNewer edit →
Line 2: Line 2:


'''<u>Prerequisites:</u>'''
'''<u>Prerequisites:</u>'''
* Ignition ON and Engine ON.
* Ignition ON and Engine OFF.
* No Fault Codes stored.
* Transmission Oil Temperature must be between 60 °C and 90 °C.
** If the procedure does not succeed in the first try, make sure the temperature is above 80 °C.
* All driving and braking has to be done in partial load, avoid full throttle/braking!
* Normally the adaptation needs to be carried out when:
** Transmission Control Module has been recoded
** Input Shaft has been replaced
** Hydraulic Unit has been replaced
** Transmission Control Module has been replaced
** Transmission has been replaced


'''[Select]'''<br>
'''[01 - Engine]'''<br>
'''[Fault Codes - 02]'''<br>
'''[Clear Codes -05]'''<br>


'''[Select]'''<br>
'''[02 - Transmission]'''<br>
'''[Adaptation - 10]'''<br>
Channel 000<br>
Channel 000<br>
'''[Read]'''<br>
'''[Read]'''<br>

Revision as of 19:03, 5 October 2006

Manually Generating Readiness

Prerequisites:

  • Ignition ON and Engine OFF.

[Select]
[01 - Engine]
[Fault Codes - 02]
[Clear Codes -05]

Channel 000
[Read]
[Save]
[Done, Go Back]
[Measuring Blocks - 08]
Block 010 (in 1st Row)
Block 011 (in 2nd Row)
[Go!]
Check fields 2, specification is ADP OK.

  • Move the selector lever in position D and drive with partial load 20 m / 70 ft forward, then brake to standstill.
  • Hold the brake for 10 seconds.
  • Move the selector lever in position R and drive with partial load 20 m / 70 ft reverse, then brake to standstill.
  • Hold the brake for 10 seconds.

The procedure needs to be repeated at least 5 times and can be repeated up to 10 times until the measuring values show ADP OK.
[Done, Go Back]
[Close Controller, Go Back - 06]

Retrieved from "https://wiki.ross-tech.com/wiki/index.php?title=Readiness_-_APB_Engine_Code&oldid=2880"
Contact Privacy Accessibility