Difference between revisions of "00003"
From Ross-Tech Wiki
RtWiKiSyS0p (talk | contribs) |
RtWiKiSyS0p (talk | contribs) |
||
| Line 39: | Line 39: | ||
* When found in [[Audi A3/S3 (8P)]]: [[Audi A3 (8P) Instrument Cluster|Instrument Cluster]]: | * When found in [[Audi A3/S3 (8P)]]: [[Audi A3 (8P) Instrument Cluster|Instrument Cluster]]: | ||
** Check/Perform Instrument Cluster Service Interval Settings (Adaptation Channels 42, 43, 44, 45 and 49) | ** Check/Perform Instrument Cluster Service Interval Settings (Adaptation Channels 42, 43, 44, 45 and 49) | ||
| + | * When found in [[VW Golf (1K) Brake Electronics (MK60EC1)|Brake Electronics (MK60EC1)]]: | ||
| + | ** Replacing the Brake Electronics Control Module (J104) but keeping the (old) Hydraulics Unit will result in the Intake and Disconnecting Valves not being synchronized. A [[VW Golf (1K) Brake Electronics (MK60EC1)| Basic Setting for the Intake/Disconnecting Valves]] will solve this problem. | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 18:27, 16 February 2011
00003 - Control Module
00003 - Control Module: Defective
Possible Causes
- Control Module faulty
- Control Module Software Issue
Possible Solutions
- Check Control Module
- Check for Control Module Software Update
- Replace Control Module
Special Notes
- When found in Radio OR Radio Navigation System, check Measuring Value Block (MVB) 025.1 for Details.
- Measuring Value Block 025.1 (MVB) may not be supported by all Radios OR Radio Navigation Systems.
00003 - Control Module: No or Incorrect Basic Setting / Adaptation
Possible Causes
- Basic Setting(s) not performed
Possible Solutions
- Perform Basic Setting(s)
Special Notes
- When found in Control Head / Multi Media Interface (MMI), check Adaptation Channel 012 (Telephone Type) for Plausibility.
- Details for Audi A6 (4F): Multi Media Interface (MMI)
- Details for Audi A8 (4E): Multi Media Interface (MMI)
- Details for Audi Q7 (4L): Multi Media Interface (MMI)
- When found in Audi A3/S3 (8P): Instrument Cluster:
- Check/Perform Instrument Cluster Service Interval Settings (Adaptation Channels 42, 43, 44, 45 and 49)
- When found in Brake Electronics (MK60EC1):
- Replacing the Brake Electronics Control Module (J104) but keeping the (old) Hydraulics Unit will result in the Intake and Disconnecting Valves not being synchronized. A Basic Setting for the Intake/Disconnecting Valves will solve this problem.