Difference between revisions of "Immobilizer I Immobilizer Swapping (Separate)"
From Ross-Tech Wiki
| Line 33: | Line 33: | ||
* Switch OFF the ignition and after 5 seconds switch it ON again. | * Switch OFF the ignition and after 5 seconds switch it ON again. | ||
| − | * Make sure NOT to start the car within the next 2 minutes. After that, | + | * Make sure NOT to start the car within the next 2 minutes. |
| + | |||
| + | After that, [[Immobilizer I Key Matching (Separate)|Match the vehicle Keys]]. | ||
Latest revision as of 09:31, 23 July 2014
This procedure details how to swap immobilizer control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I.
Determining IMMO-ID
[Select]
[25 - Immobilizer]
Look at the first "Extra" field. You should see something like: Immo-ID VWZ7Z0W0648696.
[Close Controller, Go Back - 06]
Immobilizer Control Module Swapping
Prerequisites:
- Battery voltage at least 12.0 V.
- Keys matched to Immobilizer Control Module
[Select]
[25 - Immobilizer]
[Login - 11]
- 4-digit PIN
- Enter zero followed by the 4-digit PIN. For example, if your PIN is 1234, enter 01234.
[Do it!]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
- Switch OFF the ignition and after 5 seconds switch it ON again.
- Make sure NOT to start the car within the next 2 minutes.
After that, Match the vehicle Keys.