Difference between revisions of "VW Jetta (AJ/16) Manual Heating/Air Conditioning"
From Ross-Tech Wiki
(Created page with "__FORCETOC__ == Coding == '''This module does not support coding!''' == Basic Setting ==") |
|||
| Line 7: | Line 7: | ||
== Basic Setting == | == Basic Setting == | ||
| + | |||
| + | * The Manual Heating/Air Conditioning controller does not require a scan tool to perform the Basic Settings for the Activation of the A/C Compressor, please use the following instructions below. | ||
| + | **Position the blower switch to the first or second position | ||
| + | **Position the air distribution control to 'Vent' | ||
| + | **Position the interior temperature control to 'Cold', turn to the stop | ||
| + | **Start the Vehicle's engine while in Park/Neutral | ||
| + | **Simultaneously press/ hold the AC and Defrost buttons until the AC and recirculation buttons illuminate | ||
| + | **Cycle the ignition and check for fault codes in the 08-Auto HVAC and proper HVAC system operation. | ||
| + | |||
| + | ==== Special Notes ==== | ||
| + | |||
| + | *This procedure above, must be competed when: | ||
| + | **The J301-Air conditioning system control unit is replaced. | ||
| + | **The fault code [[00898]]-005 will not clear. | ||
Revision as of 13:17, 2 January 2015
Coding
This module does not support coding!
Basic Setting
- The Manual Heating/Air Conditioning controller does not require a scan tool to perform the Basic Settings for the Activation of the A/C Compressor, please use the following instructions below.
- Position the blower switch to the first or second position
- Position the air distribution control to 'Vent'
- Position the interior temperature control to 'Cold', turn to the stop
- Start the Vehicle's engine while in Park/Neutral
- Simultaneously press/ hold the AC and Defrost buttons until the AC and recirculation buttons illuminate
- Cycle the ignition and check for fault codes in the 08-Auto HVAC and proper HVAC system operation.
Special Notes
- This procedure above, must be competed when:
- The J301-Air conditioning system control unit is replaced.
- The fault code 00898-005 will not clear.