Difference between revisions of "VW Golf (1K) Door Electronics Driver"

Revision as of 16:34, 9 September 2015

In the US/Canadian market, direct replacement CAN Protocol 2nd and 3rd Generation Front door control modules (Addresses 42 and 52) may not be available from the dealer. This thread should be helpful: Replacement 4th Generation door control modules in Mk5 Golf platform models

ST?ID=44849 | ST?ID=59513 | ST?ID=52656 | ST?ID=60412

@@ Line 17: / Line 17: @@
 === Special Notes ===
-* In the US/Canadian market, direct replacement CAN Protocol 2nd and 3rd Generation Front door control modules (Addresses 42 and 52) may not be available from the dealer.  To the best of our knowledge this issue is limited to early ''(roughly 2005.5 through 2007)'' 1K chassis VW Golf and Jetta models.  The modules in question are simply dropped without supersession per the parts catalog so they must be ordered by VIN.
+* In the US/Canadian market, direct replacement CAN Protocol 2nd and 3rd Generation Front door control modules (Addresses 42 and 52) may not be available from the dealer.  This thread should be helpful: [http://forums.ross-tech.com/showthread.php?4031-Replacement-4th-Generation-door-control-modules-in-Mk5-Golf-platform-models Replacement 4th Generation door control modules in Mk5 Golf platform models]
-When 4th Generation UDS Protocol Front door modules are sold and installed as replacement modules they may not communicate diagnostically until the 19-CAN Gateway is replaced.  Furthermore, the Left Front (#42) in addition to the Right Front (#52) modules must be replaced as a matching pair to eliminate rear door communication issues because the new UDS protocol units show the rear doors as sub system slaves rather than traditional address words 62 and 72 as found from production.
 <font color=white>ST?ID=44849 | ST?ID=59513 | ST?ID=52656 | ST?ID=60412</font>