VW Touareg (7P) Trunk Electronics: Difference between revisions
From Ross-Tech Wiki
Table Of Contents
- 1. Security Access
- 2. Coding
-
3.
Basic Setting
- 3.1.3 Rear Lid relearn
No edit summary |
No edit summary |
||
Line 21: | Line 21: | ||
== Basic Setting == | == Basic Setting == | ||
=== Rear Lid relearn === | === Rear Lid relearn === | ||
'''<u>Prerequisites:</u>'''<br> | |||
* Rear Lid closed | |||
* Transport mode NOT active | |||
* No rear lid obstructions or damage to the vehicle | |||
* Park assist functions correctly, no errors (If equipped) | |||
* DTC B2010 - No Basic Setting stored | |||
* Battery voltage at least 12.0V | |||
* Vehicle is on a flat level surface | |||
'''[Select]'''<br> | '''[Select]'''<br> |
Revision as of 16:52, 8 March 2016
This page applies to vehicles such as the Skoda Octavia (5E), Skoda Superb (3T), VW Sharan (7N) and VW Touareg
with (7P) with Address-6D: Trunk Elect. Component: HDSG-Modul. This can be identified by evaluating the data
in the Auto-Scan:
Address 6D: Trunk Elect. (----) Labels: 7N0-959-107.clb Part No SW: 7P6 959 107 C HW: 7P6 959 107 Component: HDSG-Modul ASAM Dataset: EV_HeckkTouar 202142
Security Access
- Security Access codes will appear when connected to the control module with VCDS.
Coding
- Coding information is found using the Long Coding Helper while connected to the vehicle with VCDS.
- When replacing this module save the original coding and transfer it to the new module.
Basic Setting
Rear Lid relearn
Prerequisites:
- Rear Lid closed
- Transport mode NOT active
- No rear lid obstructions or damage to the vehicle
- Park assist functions correctly, no errors (If equipped)
- DTC B2010 - No Basic Setting stored
- Battery voltage at least 12.0V
- Vehicle is on a flat level surface
[Select]
[6D-Trunk Elect.]
[Basic Settings - 04]
Select Adapt flap opening angle from the drop-down menu.
[Go!]
The rear lid Basic Settings will now begin and the rear lid will open.
Finished Correctly (or similar) should be displayed.
- When the rear lid has stopped, close the rear lid using the E406 switch.
[Stop]
[Done, Go Back]
- Check for fault codes, clear if needed.
[Close Controller, Go Back - 06]
- Check for proper operation
- Re-check for faults
Internal use reference: ST?ID=66024
No categories.