Readiness - APB Engine Code: Difference between revisions
Table Of Contents
| Line 57: | Line 57: | ||
''Evap purge test''<br> | ''Evap purge test''<br> | ||
Select group | Select group 070<br> | ||
'''[Go]'''<br> | '''[Go]'''<br> | ||
'''[Switch to basic settings]'''<br> | '''[Switch to basic settings]'''<br> | ||
Leave it in Basic Settings until the fourth field reads | Leave it in Basic Settings until the fourth field reads EVAP OK<br> | ||
'''[Switch to Meas. Blocks]'''<br> | '''[Switch to Meas. Blocks]'''<br> | ||
''A/F control test''<br> | |||
'' | |||
Select group 107<br> | |||
'''[ | '''[Go]'''<br> | ||
'''[ | '''[Switch to basic settings]'''<br> | ||
Leave it in Basic Settings until the fourth field reads Syst.OK<br> | |||
'''[Switch to Meas. Blocks]'''<br> | |||
'''[ | |||
Revision as of 19:37, 5 October 2006
Manually Generating Readiness
- Ignition ON and Engine OFF
Reading and clearing fault codes
[Select]
[01 - Engine]
[Fault Codes - 02]
[Clear Codes -05]
[Done, Go Back]
Throttle Body Alignment
[Measuring Blocks - 08]
Select group 060
[Go]
[Switch to basic settings]
Once you do this you will see the top right display say ADP RUN. Leave it in Basic Settings until the fourth field reads ADP OK.
[Switch to Meas. Blocks]
Transmission kickdown (applies to Auto Trans vehicles only!)
Select group 063
[Go]
[Switch to basic settings]
Once you do this you will see the top right display say ADP RUN. Leave it in Basic Settings until the fourth field reads ADP OK.
[Switch to Meas. Blocks]
[Done, Go Back]
[Close Controller, Go Back]
- Ignition ON and Engine ON at idle
Fuel leakage test
[Select]
[01 - Engine]
[Measuring Blocks - 08]
Select group 071
[Go]
[Switch to basic settings]
Leave it in Basic Settings until the fourth field reads Syst.OK
[Switch to Meas. Blocks]
Evap purge test
Select group 070
[Go]
[Switch to basic settings]
Leave it in Basic Settings until the fourth field reads EVAP OK
[Switch to Meas. Blocks]
A/F control test
Select group 107
[Go]
[Switch to basic settings]
Leave it in Basic Settings until the fourth field reads Syst.OK
[Switch to Meas. Blocks]
No categories.