Audi TT (8N) Central Locking

Special Procedures

Remote Control Clearing

Clearing of all memory potions, e.g. in case of a lost key.

[Select]
[35 - Central Locking]
[Adaptation - 10]
Channel 000.
[Read]
[Save] a new value of 0
[Done, Go Back]
[Close Controller, Go Back - 06]

---

Remote Control Synchronization

• Press any button on remote control.
  

If vehicle does not respond by locking or unlocking:

• Lock and unlock vehicle within 30 seconds using driver-side lock.
  
• Now check function of synchronized remote control.
  

---

Remote Control Matching

[Select]
[35 - Central Locking]
[Adaptation - 10]
Channel 021.
[Read]

• Choose the memory position you want the new key be matched on by entering it's number (e.g. "3" for memory position 3). Make sure to TYPE IN the number instead of scrolling up to it, otherwise you will not be able to click [Test].

[Test]

• Now press any button on the remote you want to match.
• The meas. block field above will change from Not Recogn. to Recognized.

[Save]

[Done, Go Back]
[Close Controller, Go Back - 06]

Note: You can check the current memory positions using Meas. Block 006.

Special Notes

The 8N platform central locking module has assigned positions, like parking spots 1, 2, 3 and 4, for each remote. This is critical when matching new remotes.

• If you are having problems with the Remote Control Matching, please pay special attention to the instructions above:
  • Make sure to TYPE IN the number instead of scrolling up to it, otherwise you will not be able to click [Test].
    

• If Adaptation Channel 21 is not available the control module does NOT support matching remotes with VCDS (or any scan tool). In those cases the remote matching procedure as per the Repair Manual and/or vehicle Owner's Manual will need to be completed.
  • In those cases, Measuring Block group 006.3 can still be used to verify the positions.