01130: Difference between revisions
From Ross-Tech Wiki
Table Of Contents
-
1.
01130 - ABS Operation
-
1.1.1
01130 - ABS Operation: Implausible Signal
- 1.1.1.2 Possible Causes
- 1.1.2.2 Possible Solutions
- 1.1.3.2 Special Notes
-
1.1.1
01130 - ABS Operation: Implausible Signal
RtWiKiSyS0p (talk | contribs) New page: __FORCETOC__ == 01130 - ABS Operation == === 01130 - ABS Operation: Implausible Signal === ==== Possible Causes ==== * Wiring from/to Brake Electronics (J104) faulty ** Electrical Inter... |
RtWiKiSyS0p (talk | contribs) No edit summary |
||
| Line 6: | Line 6: | ||
==== Possible Causes ==== | ==== Possible Causes ==== | ||
* Wiring from/to Brake Electronics (J104) faulty | * Fuse(s) faulty | ||
* Modifications/Retrofits incompatible | |||
* Wiring from/to Brake Electronics Control Module (J104) faulty | |||
** Electrical Interference from External Sources | ** Electrical Interference from External Sources | ||
*** High Frequency Radiation (e.g. non-insulated Ignition Cable) | *** High Frequency Radiation (e.g. non-insulated Ignition Cable) | ||
* Brake Electronics Control Module (J104) faulty | |||
==== Possible Solutions ==== | ==== Possible Solutions ==== | ||
* Check Wiring from/to Brake Electronics (J104) | * Check Fuse(s) | ||
* Check Vehicle for Modifications/Retrofits | |||
** Temporarily remove Modifications/Retrofits (including Wiring) | |||
* Check Wiring from/to Brake Electronics Control Module (J104) | |||
* Check Brake Electronics Control Module (J104) | |||
==== Special Notes ==== | |||
* This Fault Code can only be cleared after performing a Test Drive above 20 km/h (13 mph). | |||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 11:49, 14 November 2011
01130 - ABS Operation
01130 - ABS Operation: Implausible Signal
Possible Causes
- Fuse(s) faulty
- Modifications/Retrofits incompatible
- Wiring from/to Brake Electronics Control Module (J104) faulty
- Electrical Interference from External Sources
- High Frequency Radiation (e.g. non-insulated Ignition Cable)
- Electrical Interference from External Sources
- Brake Electronics Control Module (J104) faulty
Possible Solutions
- Check Fuse(s)
- Check Vehicle for Modifications/Retrofits
- Temporarily remove Modifications/Retrofits (including Wiring)
- Check Wiring from/to Brake Electronics Control Module (J104)
- Check Brake Electronics Control Module (J104)
Special Notes
- This Fault Code can only be cleared after performing a Test Drive above 20 km/h (13 mph).