Difference between revisions of "P119A/004506"
From Ross-Tech Wiki
| Line 23: | Line 23: | ||
** (N276) ''Fuel Pressure Regulating Valve'' resistance should be approximately 1 to 5 Ω | ** (N276) ''Fuel Pressure Regulating Valve'' resistance should be approximately 1 to 5 Ω | ||
** (N290) ''Fuel Metering valve'' resistance should be approximately 0.8 to 5 Ω | ** (N290) ''Fuel Metering valve'' resistance should be approximately 0.8 to 5 Ω | ||
| − | + | * If found with a TFSI engine and [[16555/P0171/000369]] - Fuel Trim; Bank 1: System Too Lean is also flagged, this could be caused by a failed rear main seal. | |
| + | ** [http://forums.ross-tech.com/showthread.php?2612-TFSI-Oil-leak-Not-a-VCDS-releated-question-or-is-it TFSI - Oil leak - Not a VCDS releated question? or is it?] | ||
__FORCETOC__ | __FORCETOC__ | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Revision as of 11:01, 24 March 2015
P119A/004506 - Fuel Pressure Sensor (G247) : Malfunction
Possible Symptoms
- Malfunction Indicator Light (MIL) active
- Reduced fuel economy and engine performance
Possible Causes
- Faulty Fuel Pressure Sensor (G247)
- Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
- Faulty HPFP
Possible Solutions
- Replace Fuel Pressure Sensor (G247)
- Check Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
- Replace HPFP
Special Notes
- The Fuel Pressure Regulator Valve (N276) or Fuel Metering valve (N290) on the HPFP can fail.
- (N276) Fuel Pressure Regulating Valve resistance should be approximately 1 to 5 Ω
- (N290) Fuel Metering valve resistance should be approximately 0.8 to 5 Ω
- If found with a TFSI engine and 16555/P0171/000369 - Fuel Trim; Bank 1: System Too Lean is also flagged, this could be caused by a failed rear main seal.