Difference between revisions of "VW Touareg (7P) Trunk Electronics"

From Ross-Tech Wiki
Line 35: Line 35:
 
Select '''Adapt flap opening angle''' from the drop-down menu.<br>
 
Select '''Adapt flap opening angle''' from the drop-down menu.<br>
 
'''[Go!]'''<br>
 
'''[Go!]'''<br>
The rear lid Basic Settings will now begin and the rear lid will open.<br>
+
The rear lid Basic Settings will now begin
''Finished Correctly (or similar) should be displayed.''<br>
+
* If the the rear lid begins to open let it continue.<br>
*When the rear lid has stopped, close the rear lid using the E406 switch.<br>
+
* If the read lid does NOT begin to open, operate the switch on the Driver's door -or- the switch on the outside of the lid.<br>
 +
**"Unknown" may be shown on-screen during the procedure.
 +
*When the rear lid has stopped opening, close the rear lid using Driver's door switch -or- the E406 switch on the inside lid trim.<br>
 +
''Finished Correctly should be displayed after the procedure completes.''<br>
 
'''[Stop]'''<br>
 
'''[Stop]'''<br>
 
'''[Done, Go Back]'''<br>
 
'''[Done, Go Back]'''<br>

Revision as of 08:55, 12 July 2018

This page applies to vehicles such as the Skoda Octavia (5E), Skoda Superb (3T), VW Sharan (7N) and VW Touareg with (7P) with Address-6D: Trunk Elect. Component: HDSG-Modul.

This can be identified by evaluating the data in the Auto-Scan:

Address 6D: Trunk Elect. (----)       Labels: 7N0-959-107.clb
  Part No SW: 7P6 959 107 C    HW: 7P6 959 107 
  Component: HDSG-Modul
  ASAM Dataset: EV_HeckkTouar 202142

Security Access

  • Security Access codes will appear when connected to the control module with VCDS.

Coding

  • Coding information is found using the Long Coding Helper while connected to the vehicle with VCDS.
  • When replacing this module save the original coding and transfer it to the new module.

Basic Setting

Rear Lid relearn

Prerequisites:

  • Rear Lid closed
  • Transport mode NOT active
  • No rear lid obstructions or damage to the vehicle
  • Park assist functions correctly, no errors (If equipped)
  • DTC B2010 - No Basic Setting stored
  • Battery voltage at least 12.0V
  • Vehicle is on a flat level surface


[Select]
[6D-Trunk Elect.]
[Basic Settings - 04]
Select Adapt flap opening angle from the drop-down menu.
[Go!]
The rear lid Basic Settings will now begin

  • If the the rear lid begins to open let it continue.
  • If the read lid does NOT begin to open, operate the switch on the Driver's door -or- the switch on the outside of the lid.
    • "Unknown" may be shown on-screen during the procedure.
  • When the rear lid has stopped opening, close the rear lid using Driver's door switch -or- the E406 switch on the inside lid trim.

Finished Correctly should be displayed after the procedure completes.
[Stop]
[Done, Go Back]

  • Check for fault codes, clear if needed.

[Close Controller, Go Back - 06]

  • Check for proper operation
  • Re-check for faults


Internal use reference: ST?ID=66024