VW Golf (5K) AirbagVW10
Coding
AirbagVW10 modules are Index based Long Coded. When using one of our professional grade HEX interfaces, the Airbag Coding Assistant should be used as explained on the following page of our interactive manual. and our Airbag Coding tech tip.
Adaptation
Used to deactivate individual airbag components (see repair manual for details).
Basic Setting
Seat Occupied Recognition Control Module (J706)
If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the basic setting has to be performed.
Prerequisites:
- The vehicle is between 5° and 35°C (40° ~ 95°F).
- Battery voltage no less than 12.4 V.
- Passenger seat is empty and in normal position.
- Seatbelt must NOT be plugged in.
- No faults in the system.
[Select]
[15 - Airbags]
[Security Access - 16]
Enter the code shown in the pop-up balloon to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Select Seat occupied recognition serial number.
[Go!] to activate the Basic Setting.
After the result of Finished Correctly appears click [Stop]
The Seat occupied recognition serial number reset has been performed. Proceed directly to the Seat Occupied Recognition Control Module (J706): Reset procedure!
Seat Occupied Recognition Control Module (J706): Reset
If a repair on the Seat Occupied Recognition has been performed, including the above basic settings procedure, a reset has to be performed too.
Prerequisites:
- The vehicle is between 5° and 35°C (40° ~ 95°F).
- Battery voltage no less than 12.4 V.
- Passenger seat is empty and in normal position.
- Seatbelt must NOT be plugged in.
- No faults in the system.
[Select]
[15 - Airbags]
[Security Access - 16]
Enter the code shown in the pop-up balloon to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Select Resetting seat occupied recognition.
[Go!] to activate the Basic Setting.
After the result of Finished Correctly appears click [Stop]
The reset has been performed.
[Done, Go Back]
[Fault Codes - 02] Faults should NOT be stored
[Close Controller, Go Back - 06]
Special Notes
- If you click the basic settings tests out of sequence, you may need to exit the module, cycle the key and repeat the entire process.
- If the procedure results in an error message of any type or does not complete as expected:
- Registered users can send a complete Auto-Scan via email.
- Include specific details regarding which component(s) were replaced in the vehicle.
- Include specific details regarding the exact results when completing the basic settings procedure.E?ID=110711 and ST?ID=34591