VW MQB Headlight Regulation
This page directly applies to VW Touareg (7P) and VW Golf (5G/AU) Chassis vehicles with Headlight Regulation MQB headlights. This can be identified by evaluating the data in the Auto-Scan:
Address 55: Headlight Range (J745) Labels: 7P6-907-357.clb Part No SW: 7P6 907 357 C HW: 7P6 907 357 B Component: AFS-ECU H01 0091 ASAM Dataset: EV_HeadlRegulAFSMQBMLB 001001
Address 55: Headlight Range (J745) Labels: 7P6-907-357.clb Part No SW: 7P6 907 357 D HW: 7P6 907 357 A Component: AFS-ECU H07 0090 ASAM Dataset: EV_HeadlRegulVWAFSMQB 001120
This page can also be used as a general Basic Settings guide for Facelift MQB cars with LED headlights using address 4B instead of 55 per this scan example:
Address 4B: Multifunc. Module (J745) Labels:| 3Q0-907-338-V1.clb Part No SW: 3Q0 907 338 HW: 3Q0 907 338 Component: FCM MQB Low 002 0286 ASAM Dataset: EV_MultiModulContiVW48X 001010
Coding
This control module is Long Coded. It is strongly advised to run and save a complete Auto-Scan prior to replacement so the original coding can be copied and pasted directly into the new control module. Coding information is available using the Long Coding Helper in VCDS.
Adaptation
Security Access
- Is not necessary for Coding or Basic Settings.
Basic Setting
Headlight Adjustment
Prerequisites:
- Vehicle must be parked on level ground and settled on its suspension
[Select]
[55 - Xenon Range] or [4B - Multifunc. Module] when applicable
[Basic Settings - 04]
Select IDE03675 Basic headlamp setting from the drop-down menu.
[Go!] to activate the Basic Setting.
- The meas. block field will show Running.
- Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.
[Stop] after any needed mechanical adjustments are completed.
Select IDE03676 Acknowledge basic setting
[Go!] to activate the Basic Setting.
The adjustment should now be learned.
[Stop]
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]