00515

From Ross-Tech Wiki
Revision as of 07:50, 13 February 2007 by RtWiKiSyS0p (talk | contribs)

00515 - Camshaft Position (Hall) Sensor (G40)

00515 - Camshaft Position (Hall) Sensor (G40): No Signal

Possible Causes

  • Wiring to Camshaft Position (Hall) Sensor (G40) faulty
  • Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

  • Check Wiring to Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Engine Control Module

Special Notes

  • Some older engines store this code as long as the engine is not running, if in doubt read fault codes with the engine running again.


00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to Plus

Possible Causes

  • Wiring to Camshaft Position (Hall) Sensor (G40) faulty
  • Camshaft Position (Hall) Sensor (G40) Installation faulty
  • Camshaft Timing Out of Specification
  • Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

  • Check Wiring to Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Camshaft Position (Hall) Sensor (G40)
  • Check Camshaft Timing
  • Check/Replace Engine Control Module


00515 - Camshaft Position (Hall) Sensor (G40): Short to Ground

Possible Symptoms

  • Power Loss
  • Emissions not OK
  • High Fuel Consumption

Possible Causes

  • Wiring to Camshaft Position (Hall) Sensor (G40) faulty
  • Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

  • Check Wiring to Camshaft Position (Hall) Sensor (G40)
  • Check/Replace Camshaft Position (Hall) Sensor (G40)
Retrieved from "http://wiki.ross-tech.com/wiki/index.php?title=00515&oldid=3240"