00288
From Ross-Tech Wiki
00288 - Steering Column Lock Actuator (N360)
00288 - Steering Column Lock Actuator (N360): No Signal
00288 - Steering Column Lock Actuator (N360): Implausible signal
00288 - Steering Column Lock Actuator (N360): Open Circuit
00288 - Steering Column Lock Actuator (N360):Open Circuit / Short to ground
00288 - Steering Column Lock Actuator (N360): Open Circuit / Short to positive
00288 - Steering Column Lock Actuator (N360): Electrical fault in Circuit
00288 - Steering Column Lock Actuator (N360): Defective
Possible Symptoms
- Ignition power will NOT switch on
- Steering column will or will not lock
Possible Causes
- Wiring/Connections from/to N360
- Faulty N360
Possible Solutions
- Check wiring/connections from/to N360
- Check/Replace failed N360
Special Notes
- If the ignition will not switch on, the communication with the Access Start controller still maybe possible, Try this:
- Turn on the hazards, press the brake pedal and hold the flash to pass
- This will wake-up(activate) the CAN-Bus and may allow limited communication to the vehicle
- If present clear the N360 fault code and if the vehicle's ignition power is now active, suspect a failed N360.
- When found on the Audi A6/S6/RS6/allroad (4F) the N360 is part of the steering column and is not available separately from the Audi at this time.
- See TSB / TPI 2040593 for possible part/software update when found in Audi Q7 and A6 (2005 to 2014).
- Vehicles equipped with Immobilizer 4C or higher will require an online connection with VW/Audi/Bentley to correctly adapt the new N360 to the vehicle. Registered users can contact us directly via email about possible adaptation procedures for other immobilizer types (3 and 4A) . Inquiries must include the full Auto-Scan with VIN.
- Replacement with a used N360 is not recommended.