VW Touareg (7P) Trunk Electronics

From Ross-Tech Wiki
Revision as of 10:56, 12 May 2016 by Dana (talk | contribs)

This page applies to vehicles such as the Skoda Octavia (5E), Skoda Superb (3T), VW Sharan (7N) and VW Touareg with (7P) with Address-6D: Trunk Elect. Component: HDSG-Modul.

This can be identified by evaluating the data in the Auto-Scan:

Address 6D: Trunk Elect. (----)       Labels: 7N0-959-107.clb
  Part No SW: 7P6 959 107 C    HW: 7P6 959 107 
  Component: HDSG-Modul
  ASAM Dataset: EV_HeckkTouar 202142

Security Access

  • Security Access codes will appear when connected to the control module with VCDS.

Coding

  • Coding information is found using the Long Coding Helper while connected to the vehicle with VCDS.
  • When replacing this module save the original coding and transfer it to the new module.

Basic Setting

Rear Lid relearn

Prerequisites:

  • Rear Lid closed
  • Transport mode NOT active
  • No rear lid obstructions or damage to the vehicle
  • Park assist functions correctly, no errors (If equipped)
  • DTC B2010 - No Basic Setting stored
  • Battery voltage at least 12.0V
  • Vehicle is on a flat level surface


[Select]
[6D-Trunk Elect.]
[Basic Settings - 04]
Select Adapt flap opening angle from the drop-down menu.
[Go!]
The rear lid Basic Settings will now begin and the rear lid will open.
Finished Correctly (or similar) should be displayed.

  • When the rear lid has stopped, close the rear lid using the E406 switch.

[Stop]
[Done, Go Back]

  • Check for fault codes, clear if needed.

[Close Controller, Go Back - 06]

  • Check for proper operation
  • Re-check for faults


Internal use reference: ST?ID=66024