VW Touareg (7P) Steering Wheel Electronics

From Ross-Tech Wiki
Revision as of 11:20, 2 May 2013 by Dana (talk | contribs)

Coding

Coding for this Control Module is normally done via Software Version Management (SVM). If the old Control Module is still accessible read/copy it's Coding to the new Module. If this is not possible each coding inquiry has to be configured per vehicle based on the complete Auto-Scan and vehicle repair history. Registered Customers can email directly with each request.


Security Access

  • 40168 = Basic Setting Enabling


Basic Setting

Steering Angle Sensor (G85) Calibration

[Select]
[16 - Steering Wheel]

Turn steering wheel at least 30 ° left or right and back straight ahead (Tolerance: ±5.0 °).

[Security Access - 16]
Enter 40168
[Do It!]

[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
After a successful basic setting, field 3 should say "OK".
[Done, Go Back]

[Meas. Blocks - 08]
Group 033 Field 3 (Steering Angle Sensor -G85-)
Specification: 0.0 °
Tolerance (when straight): ±1.5 °
[Done, Go Back]


Notes:

  • To confirm the status of the G85 calibration see MVB group 032.
  • If the basic setting group results in an error message verify the live G85 reading is ±1.5 °. Readings such as 359° would indicate the slip ring is mechanically out one full turn.
  • The slip ring is the 16-Steering Wheel Electronics module. If the vehicle deployed Airbag(s) and the slip ring was replaced make sure the module is long coded using VCDS.
Retrieved from "http://wiki.ross-tech.com/wiki/index.php?title=VW_Touareg_(7P)_Steering_Wheel_Electronics&oldid=7076"