00515

From Ross-Tech Wiki

Revision as of 09:16, 9 August 2006 by RtWiKiSyS0p (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Table Of Contents

1. 00515 - Camshaft Position (Hall) Sensor (G40)
- 1.1.1 00515 - Camshaft Position (Hall) Sensor (G40): No Signal
  - 1.1.1.2 Possible Causes
  - 1.1.2.2 Possible Solutions
  - 1.1.3.2 Special Notes
- 1.2.1 00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to B+
  - 1.2.1.6 Possible Causes
  - 1.2.2.6 Possible Solutions

00515 - Camshaft Position (Hall) Sensor (G40)

00515 - Camshaft Position (Hall) Sensor (G40): No Signal

Possible Causes

Wiring to Camshaft Position (Hall) Sensor (G40) faulty
Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

Check Wiring to Camshaft Position (Hall) Sensor (G40)
Check/Replace Camshaft Position (Hall) Sensor (G40)
Check/Replace Engine Control Module

Special Notes

Some older engines store this code as long as the engine is not running, if in doubt read fault codes with the engine running again.

00515 - Camshaft Position (Hall) Sensor (G40): Open or Short to B+

Possible Causes

Wiring to Camshaft Position (Hall) Sensor (G40) faulty
Camshaft Position (Hall) Sensor (G40) faulty

Possible Solutions

Check Wiring to Camshaft Position (Hall) Sensor (G40)
Check/Replace Camshaft Position (Hall) Sensor (G40)
Check/Replace Engine Control Module

Retrieved from "https://wiki.ross-tech.com/wiki/index.php?title=00515&oldid=2751"