Headlight Aim Control Audi (8K) / (8T)
From Ross-Tech Wiki
Coding
Coding documentation will be shown in VCDS while connected to the vehicle. This module requires a Security Access prior to coding.
Adaptation
Channel 010: Tourist Solution
When driving in countries where driving is performed on the opposite side as in the native country the headlights must be changed over to avoid blinding the oncoming traffic.
- 0 = Disabled
- 1 = Enabled
Security Access
Security Access codes will be shown in VCDS while connected to the vehicle.
Basic Setting
Headlight Adjustment
[Select]
[55 - Xenon Range]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
- The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
- Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.
[ON/OFF/Next]
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]