Audi A4 (8E) Automatic Roof

Adaptation

Channel 01: Reset

Prerequisites:

• Automatic Roof closed
• Measuring Value Blocks (MVB) OK

To reset the switch positions, save a new value of 1.

Special Notes

• If Adaptation will not set with only the 02000 fault present, check TSB 61-08-05 (2010940, NAR only)
• If fault code 00003 - Control Module: Defective -or- Control Module: No or Incorrect Basic Setting / Adaptation will not clear after replacing the 26 module try locking the vehicle doors so the CAN Bus modules go into sleep mode. Upon waking back up, the internal CAN Bus modules on the Comfort Bus may begin to communicate properly.

Measuring Block Data

Reading Roof Electronics Switch Conditions, Electric Power Top Closed

Measuring Block Group 001 (Roof Closed)
Field 2								X	Field 3							Data
1	1	0	1	1	0	1	0		1	0	X	1	0	1	0	F201
																F290
																F293
																F200
																X
																Not used, always "0"
																F292
																X
																F171
																F202
																F294
																F295
																F172
																Switch Point for Bow UP
																Switch Point for Bow OPEN
																Switch Point for Bow DEAD CENTER

Reading Roof Electronics Switch Conditions, Electric Power Top Opened

Measuring Block Group 001 (Roof Opened)
Field 2								X	Field 3							Data
0	0	1	0	1	0	0	1		1	0	X	1	0	1	0	F201
																F290
																F293
																F200
																X
																Not used, always "0"
																F292
																X
																F171
																F202
																F294
																F295
																F172
																Switch Point for Bow UP
																Switch Point for Bow OPEN
																Switch Point for Bow DEAD CENTER

Video Link

A4 Top Operation

http://www.youtube.com/watch?v=Q_SumTD87lQ

• Note that this video will be replaced with a more detailed A4 Cabriolet Top Operation video.