VW Tiguan (5N) Airbag VW10
Coding
Airbag VW10 modules are Index based short coded. When using one of our professional grade HEX interfaces, the Airbag Coding Assistant should be used as explained on the following page of our interactive manual. and our Airbag Coding tech tip.
Adaptation
Used to deactivate individual airbag components (see repair manual for details).
Basic Setting
Seat Occupied Recognition Control Module (J706)
If the Seat Occupied Recognition Control Module (J706) or the seat itself have been replaced, the basic setting has to be performed.
[Select]
[15 - Airbags]
[Security Access - 16]
Enter 10522, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]
The reset has been performed.
[Done, Go Back]
[Close Controller, Go Back - 06]
Special Procedures
Seat Occupied Recognition Control Module (J706): Reset
If a repair on the Seat Occupied Recognition has been performed, a reset has to be performed too.
Prerequisites:
- Seat in normal position.
- Seat must NOT be occupied during the whole procedure.
- Seatbelt must NOT be plugged in.
- No faults in the system.
- Interior temperature must be between 0 °C and 37 °C (32 °F and 98 °F).
[Select]
[15 - Airbags]
[Security Access - 16]
Enter 10522, to enable the basic setting.
[Do it!]
[Adaptation - 10]
Channel 000
[Read]
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
Special Notes
Due to liability concerns, Ross Tech does not offer assistance for installing used airbag components.
- If the procedure results in an error message -or- does not complete as expected:
- Registered users can send a complete Auto-Scan via email.
- Include specific details regarding which component(s) were replaced in the vehicle.
- Include specific details regarding the exact results when completing the Basic Settings or Adaptation function procedure.