7-Speed S-Tronic Direct-Shift Gearbox (DSG/0B5)
General Information about this Transmission can be found in the Wikipedia entry. Additional information can be found in the Official Factory Repair Information.
Coding
- When replacing this Mechatronic unit Component Protection fault code(s) may be stored.
Basic Setting
Prerequisites:
- Transmission fluid level correct
- Transmission fluid temperature between 40°C - 100°C.
- TCM fault free however it is strongly recommended to check/clear all Powertrain controllers faults also.
- Key on, Engine off
- Selector lever in P
All 3 Basic Setting operations need to be completed in the order listed below
[Select]
[02 - Auto Trans]
[Basic Settings - 04]
Select Erase counter for start and stop processes
[Go!] to activate the Basic Setting.
After the result of Finished Correctly or Not Running appears click [Stop]
[Done, Go Back]
Start the Engine and leave the Selector lever in Park
[Basic Settings - 04]
Select Clutch valve calibration
[Go!] to activate the Basic Setting.
After the result of Finished Correctly appears click [Stop]
Select Distance sensor calibration
[Go!] to activate the Basic Setting.
Clunking noises from the transmission are normal
After the result of Finished Correctly appears click [Stop]
[Done, Go Back]
Switch off Ignition, wait 10 Seconds and switch it back on.
[Fault Codes - 02]
Check and clear any fault codes
[Close Controller, Go Back - 06]
Perform a test drive and check for fault codes again after doing so.
Special Notes
- Numerous Audi TPIs/TSBs exist for 0B5 transmission problems. Although a majority are flash update related some are hardware ("printed circuits"/internal wiring harness) related instead such as TPI 2022497 when P1740 - Clutch Temperature Monitoring is stored.
forums.ross-tech.com/showthread.php?2293-Audi-A4-2-0-TFSI-Quattro-s-tronic-0B5-%28DL501%29-problem&p=23158&viewfull=1#post23158