Difference between revisions of "00003"

From Ross-Tech Wiki
Line 19: Line 19:
 
* When found in Radio OR Radio Navigation System, check Measuring Value Block (MVB) 025.1 for Details.
 
* When found in Radio OR Radio Navigation System, check Measuring Value Block (MVB) 025.1 for Details.
 
** Measuring Value Block 025.1 (MVB) may not be supported by all Radios OR Radio Navigation Systems.
 
** Measuring Value Block 025.1 (MVB) may not be supported by all Radios OR Radio Navigation Systems.
 +
* When found in [[Audi A8/S8 (4E)]]: [[Audi A8 (4E) Brake Electronics]], this Fault Code may have been stored after performing an Output Test in the Brake Electronics Control Module w/o following the proper Instructions. To clear this Fault Code, please perform/repeat the following Steps 3 (THREE) times:
 +
** Switch the Ignition OFF for 5 Seconds, then Switch it ON again.
 +
** Clear Fault Codes in Brake Electronics Control Module.
  
  

Revision as of 10:28, 29 August 2014

00003 - Control Module

00003 - Control Module: Defective

Possible Causes

  • Control Module faulty
  • Control Module Software Issue

Possible Solutions

  • Check Control Module
    • Check for Control Module Software Update
  • Replace Control Module

Special Notes

  • When found in Radio OR Radio Navigation System, check Measuring Value Block (MVB) 025.1 for Details.
    • Measuring Value Block 025.1 (MVB) may not be supported by all Radios OR Radio Navigation Systems.
  • When found in Audi A8/S8 (4E): Audi A8 (4E) Brake Electronics, this Fault Code may have been stored after performing an Output Test in the Brake Electronics Control Module w/o following the proper Instructions. To clear this Fault Code, please perform/repeat the following Steps 3 (THREE) times:
    • Switch the Ignition OFF for 5 Seconds, then Switch it ON again.
    • Clear Fault Codes in Brake Electronics Control Module.


00003 - Control Module: No or Incorrect Basic Setting / Adaptation

Possible Causes

  • Basic Setting(s) not performed

Possible Solutions

  • Perform Basic Setting(s)

Special Notes