Difference between revisions of "02432"

From Ross-Tech Wiki
 
Line 1: Line 1:
__FORCETOC__
 
 
== 02432 - Supply Voltage for Left Parking Brake Motor (V282) ==
 
== 02432 - Supply Voltage for Left Parking Brake Motor (V282) ==
  
Line 24: Line 23:
 
==== Special Notes ====
 
==== Special Notes ====
  
* Make sure to cycle the Parking Brake a couple of times between checking for Fault Codes, this will ensure that the Control Module tests the related Components again.
+
* When found in [[VW Passat (3C): Parking Brake]]:
* When found in [[VW Passat (3C)]]: Parking Brake Electronics, check TSB 01-07-47 (2015075, NAR only) or TPI 2013530 (RoW) for possible Control Module Software Update which corrects Low Voltage Sensitivity.
+
** Clear Fault Codes with Engine running (to ensure proper Voltage Supply). ''When checking Voltage with this Fault Code stored, the Module may not output Power to the Motor. Try clearing Fault Codes and Operating the EPB as mentioned below before testing again.
* When checking voltage with this fault code stored, the module may not output power to the motor. Try clearing fault codes and operating the EPB as mentioned above and retesting.  
+
*** Switch Ignition OFF for about 10 Seconds
 +
*** Start the Engine and keep it running while trying to clear Fault Codes.
 +
*** Press the Parking Brake Button (E538) in 5 Second Intervals.
 +
** Check TPI 2013530 (Rest of World) or TSB 2015075/01-07-47 (North American Region) for possible Control Module Software Update which corrects Low Voltage Sensitivity. '''This Update can be considered mandatory if you have these Fault Codes stored!'''
  
 +
__FORCETOC__
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Latest revision as of 06:03, 9 September 2011

02432 - Supply Voltage for Left Parking Brake Motor (V282)

02432 - Supply Voltage for Left Parking Brake Motor (V282): Electrical Fault in Circuit

02432 - Supply Voltage for Left Parking Brake Motor (V282): Open Circuit

Possible Symptoms

  • Parking Brake Warning Light active/flashing

Possible Causes

  • Wiring/Connectors from/to Left Parking Brake Motor (V282) faulty
  • Left Parking Brake Motor (V282) Power Supply faulty
  • Left Parking Brake Motor/Caliper (V282) faulty

Possible Solutions

  • Check Wiring/Connectors from/to Left Parking Brake Motor (V282)
  • Check Left Parking Brake Motor and (V282) Power Supply
  • Perform Terminal 30 Reset
    • Remove Fuse(s) for a short Time.

Special Notes

  • When found in VW Passat (3C): Parking Brake:
    • Clear Fault Codes with Engine running (to ensure proper Voltage Supply). When checking Voltage with this Fault Code stored, the Module may not output Power to the Motor. Try clearing Fault Codes and Operating the EPB as mentioned below before testing again.
      • Switch Ignition OFF for about 10 Seconds
      • Start the Engine and keep it running while trying to clear Fault Codes.
      • Press the Parking Brake Button (E538) in 5 Second Intervals.
    • Check TPI 2013530 (Rest of World) or TSB 2015075/01-07-47 (North American Region) for possible Control Module Software Update which corrects Low Voltage Sensitivity. This Update can be considered mandatory if you have these Fault Codes stored!