Difference between revisions of "17977/P1569/005481"

From Ross-Tech Wiki
 
Line 4: Line 4:
 
==== Possible Symptoms ====
 
==== Possible Symptoms ====
  
* Cruise Control not working.<br>
+
* Cruise Control not working
  
 
==== Possible Causes ====
 
==== Possible Causes ====
  
* Wiring defective.<br>
+
* Wiring and/or Connector(s) from/to Engine Control Module (ECM) faulty/incomplete
* Cruise Control Switch (E45) Faulty.<br>
+
* Cruise Control Switch (E45) faulty
  
 
==== Possible Solutions ====
 
==== Possible Solutions ====
  
* Check wiring.<br>
+
* Check Wiring and/or Connector(s) from/to Engine Control Module (ECM)
* Check Measuring Blocks.<br>
+
* Check/Replace Cruise Control Switch (E45)
 +
** Check Measuring Value Blocks (MVB)
  
 
==== Special Notes ====
 
==== Special Notes ====
  
* If cruise control was retrofitted, check if the necessary wire between J527 (Steering Wheel Electronics) and Engine Control Module was installed too! This applies for the following models:
+
* If the Cruise Control System (CCS) was retrofitted, check the Wiring to the Engine Control Module (ECM). Depending on the Make, Model and Model Year the Hardware Signal can originate from one of the following Sources:
** Audi A3/S3 (8P) 2004+
+
** Cruise Control Switch (E45)
** Seat Altea (5P) 2004+
+
** Steering Column Control Module (J527)
** Seat Leon (1P) 2006+
+
** Central Electronics / Body Control Module (J519)
** Seat Toledo (5P) 2005+
 
** Skoda Octavia II (1Z) 2005+
 
** VW Caddy (2K) 2004+
 
** VW Eos (1F) 2006+
 
** VW Golf/Jetta/Bora V (1K/5M) 2004+
 
** VW Touran (1T) 2003+
 
  
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Latest revision as of 13:18, 13 September 2011

17977/P1569/005481 - Cruise Control Switch (E45): Implausible Signal

Possible Symptoms

  • Cruise Control not working

Possible Causes

  • Wiring and/or Connector(s) from/to Engine Control Module (ECM) faulty/incomplete
  • Cruise Control Switch (E45) faulty

Possible Solutions

  • Check Wiring and/or Connector(s) from/to Engine Control Module (ECM)
  • Check/Replace Cruise Control Switch (E45)
    • Check Measuring Value Blocks (MVB)

Special Notes

  • If the Cruise Control System (CCS) was retrofitted, check the Wiring to the Engine Control Module (ECM). Depending on the Make, Model and Model Year the Hardware Signal can originate from one of the following Sources:
    • Cruise Control Switch (E45)
    • Steering Column Control Module (J527)
    • Central Electronics / Body Control Module (J519)