Difference between revisions of "Audi A5 (8T) Active Steering"
From Ross-Tech Wiki
(Created page with " == Audi A5 (8T) Active/Dynamic Steering == == Coding == '''Coding for this Control Module is normally done via Software Version Management (SVM). If the old Control Mod...") |
|||
| Line 49: | Line 49: | ||
Check and clear fault codes.<br> | Check and clear fault codes.<br> | ||
'''[Close Controller, Go Back - 06]'''<br> | '''[Close Controller, Go Back - 06]'''<br> | ||
| + | |||
| + | <font color=white>FS#745</font> | ||
Revision as of 11:08, 2 April 2015
Audi A5 (8T) Active/Dynamic Steering
Coding
Coding for this Control Module is normally done via Software Version Management (SVM). If the old Control Module is still accessible read/copy it's Coding to the new Module.
Basic Setting
1B-Active Steering
Prerequisites:
- Battery Voltage = 12.0 - 14.0 V
- No fault codes other than 01087 - Basic Setting Not Performed
- Perform G85-Steering Angle Sensor Basic Settings found on this Ross-Tech wiki page: Audi A4/A5 (8K/8T) Steering Angle Sensor (G85) Calibration
- Continue Only after successfully completing the G85 basic settings -
- Leave the steering wheel in the straight ahead position during the next steps.
[Select]
[1B-Active Steering]
[Security Access - 16]
Enter 61378, to enable the basic setting.
[Do it!]
[Basic Settings - 04]
Group 101
[Go!]
[ON/OFF/Next]
- The results should be stored after a key cycle and fault code(s) should clear.
[Done, Go Back]
[Fault Codes - 02]
Check and clear fault codes.
[Close Controller, Go Back - 06]
FS#745