|
|
| (4 intermediate revisions by 3 users not shown) |
| Line 1: |
Line 1: |
| | __FORCETOC__ | | __FORCETOC__ |
| − | | + | The information that was on this page moved to the [[Battery Replacement]] page. |
| − | '''General Information:''' Most 2009+ Audi A4 and newer models do NOT use a separate 61-Battery Manager. In these cases battery management is a slave (subsystem) under the 19-CAN-Gateway control module. This page covers those 8T/8K/8R and newer models using a CAN Protocol 19-CAN-Gateway control module.<br>
| |
| − | <br>
| |
| − | If the vehicle in question uses a diagnostic capable 61-Battery Regulation controller this page ''should'' apply instead:
| |
| − | * [[Audi A8 (4E) Battery Replacement|61-Battery Regulation]]<br>
| |
| − | <br>
| |
| − | ----
| |
| − | | |
| − | === Long Adaptation ===
| |
| − | | |
| − | Installation of a new battery requires the use of the [http://www.ross-tech.com/vcds/tour/adaptation_screen.html#long [Long Adaptation-0A]] function under 19-CAN-Gateway control module. Follow the onscreen instructions to enter the Part Number, Vendor, and Serial Number all as one long new value.
| |
| − | | |
| − | '''<u>Prerequisites:</u>'''<br>
| |
| − | * New Audi Battery Installed
| |
| − | ** Aftermarket batteries may NOT have a valid Audi Part Number, Vendor code or Serial number. Ross-Tech cannot offer assistance if the necessary information is missing.
| |
| − | * Key On, Engine OFF
| |
| − | <br>
| |
| − | '''[Select]'''<br>
| |
| − | '''[19 - CAN-Gateway]'''<br>
| |
| − | '''[Long Adaptation-0A]'''<br>
| |
| − | Channel 004<br>
| |
| − | '''[Read]'''<br>
| |
| − | VCDS will populate instructions in the form of a pop-up balloon with the formatting. For example:
| |
| − | Format: NNNNNNNNNNN XXX ZZZZZZZZZZ
| |
| − |
| |
| − | N = Battery Part Number (11 Digits)
| |
| − | X = Battery Vendor (3 Digits)
| |
| − | Z = Battery Serial Number (10 Digits)
| |
| − | | |
| − | '''[Add to Log]''' ''Saving the original value to a log is strongly recommended''.<br>
| |
| − | Type the New Battery details into the '''New value''' field.<br>
| |
| − | * Note, the New value must be 26 (alpha numeric) total characters including the spaces! If in doubt check the saved log for the original battery formatting details.
| |
| − | '''[Test]''' <br>
| |
| − | '''[Save]'''<br>
| |
| − | | |
| − | Providing the value was accepted by the controller the new battery coding is complete.
| |
| − | | |
| − | === Special Notes ===
| |
| − | | |
| − | | |
| − | | |
| − | | |
| − | | |
| − | [[Category:Subsystems]]
| |