Immobilizer I Immobilizer Swapping (Separate)

From Ross-Tech Wiki
Revision as of 09:31, 23 July 2014 by Dana (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This procedure details how to swap immobilizer control modules on VW/Audi/Seat/Skoda vehicles with Immobilizer I.

Determining IMMO-ID

[25 - Immobilizer]
Look at the first "Extra" field. You should see something like: Immo-ID VWZ7Z0W0648696.
[Close Controller, Go Back - 06]

Immobilizer Control Module Swapping


  • Battery voltage at least 12.0 V.
  • Keys matched to Immobilizer Control Module

[25 - Immobilizer]
[Login - 11]

  • 4-digit PIN
    • Enter zero followed by the 4-digit PIN. For example, if your PIN is 1234, enter 01234.

[Do it!]

[Adaptation - 10]
Channel 000
[Done, Go Back]
[Close Controller, Go Back - 06]

  • Switch OFF the ignition and after 5 seconds switch it ON again.
  • Make sure NOT to start the car within the next 2 minutes.

After that, Match the vehicle Keys.