Difference between revisions of "P0336"
From Ross-Tech Wiki
(Created page with "__FORCETOC__ == 16720/P0336/000822 - Crankshaft Position Sensor (G28): Missing Tooth == ==== Special Notes ==== * When found in the 2005-2008 (4F) Chassis Audi A6 3.2L BKH e...") |
|||
| Line 8: | Line 8: | ||
*** Reverse polarity (swapped wires) will cause this DTC in that particular car. | *** Reverse polarity (swapped wires) will cause this DTC in that particular car. | ||
** The G28 testing procedure in the factory level repair manual is either incorrect -or- not applicable to ALL 3.2L BKH engine controllers. | ** The G28 testing procedure in the factory level repair manual is either incorrect -or- not applicable to ALL 3.2L BKH engine controllers. | ||
| − | *** The lack of 12V (Battery voltage) does not indicate a faulty module. Live testing revealed 2. | + | *** The lack of 12V (Battery voltage) does not indicate a faulty module. Live testing revealed roughly 2.5V on each wire in a fully functional 2006 3.2L A6. |
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 11:43, 23 March 2017
16720/P0336/000822 - Crankshaft Position Sensor (G28): Missing Tooth
Special Notes
- When found in the 2005-2008 (4F) Chassis Audi A6 3.2L BKH engine controller:
- Make sure the G28 wires from the sensor to the Engine controller are correctly wired per the wiring diagram.
- Reverse polarity (swapped wires) will cause this DTC in that particular car.
- The G28 testing procedure in the factory level repair manual is either incorrect -or- not applicable to ALL 3.2L BKH engine controllers.
- The lack of 12V (Battery voltage) does not indicate a faulty module. Live testing revealed roughly 2.5V on each wire in a fully functional 2006 3.2L A6.
- Make sure the G28 wires from the sensor to the Engine controller are correctly wired per the wiring diagram.