Difference between revisions of "P119A/004506"

From Ross-Tech Wiki
(Created page with "== P119A/004506 - Fuel Pressure Sensor (G247) : Malfunction == ==== Possible Symptoms ==== * Malfunction Indicator Light (MIL) active * Reduced fuel economy and engine perfo...")
 
(6 intermediate revisions by 3 users not shown)
Line 11: Line 11:
 
* Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
 
* Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
 
* Faulty HPFP
 
* Faulty HPFP
 +
* Faulty (leaking) fuel injector
  
 
==== Possible Solutions ====
 
==== Possible Solutions ====
Line 17: Line 18:
 
* Check Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
 
* Check Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
 
* Replace HPFP
 
* Replace HPFP
 +
* Check fuel injectors for leak-down
  
 
==== Special Notes ====
 
==== Special Notes ====
  
* The Fuel Pressure Regulator Valve (N276) or (N290) on the HPFP can fail.  
+
* The Fuel Pressure Regulator Valve (N276) or Fuel Metering valve (N290) on the HPFP can fail.  
** (N276) Ohm test, should be 25 to 35 ohms.
+
** (N276) ''Fuel Pressure Regulating Valve'' resistance should be approximately 1 to 5 Ω
** (N290) Ohm test, should be 450 to 1000 ohms.
+
** (N290) ''Fuel Metering valve'' resistance should be approximately 0.8 to 5 Ω
 
+
* If found with a TFSI engine and [[16555/P0171/000369]] - Fuel Trim; Bank 1: System Too Lean is also flagged, this could be caused by a failed rear main seal.
 +
** [http://forums.ross-tech.com/showthread.php?2612-TFSI-Oil-leak-Not-a-VCDS-releated-question-or-is-it TFSI - Oil leak - TFSI - Oil leak - Not a VCDS related question? or is it? ]
  
 
__FORCETOC__
 
__FORCETOC__
 
[[Category:Fault Codes]]
 
[[Category:Fault Codes]]

Revision as of 10:33, 8 January 2018

P119A/004506 - Fuel Pressure Sensor (G247) : Malfunction

Possible Symptoms

  • Malfunction Indicator Light (MIL) active
  • Reduced fuel economy and engine performance

Possible Causes

  • Faulty Fuel Pressure Sensor (G247)
  • Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
  • Faulty HPFP
  • Faulty (leaking) fuel injector

Possible Solutions

  • Replace Fuel Pressure Sensor (G247)
  • Check Wiring and/or Connector(s) from/to Fuel Pressure Sensor (G247)
  • Replace HPFP
  • Check fuel injectors for leak-down

Special Notes

  • The Fuel Pressure Regulator Valve (N276) or Fuel Metering valve (N290) on the HPFP can fail.
    • (N276) Fuel Pressure Regulating Valve resistance should be approximately 1 to 5 Ω
    • (N290) Fuel Metering valve resistance should be approximately 0.8 to 5 Ω
  • If found with a TFSI engine and 16555/P0171/000369 - Fuel Trim; Bank 1: System Too Lean is also flagged, this could be caused by a failed rear main seal.