Readiness - APB Engine Code

From Ross-Tech Wiki

Manually Generating Readiness

Prerequisites:

  • Ignition ON and Engine OFF.

[Select]
[01 - Engine]
[Fault Codes - 02]
[Clear Codes -05]

Channel 000
[Read]
[Save]
[Done, Go Back]
[Measuring Blocks - 08]
Block 010 (in 1st Row)
Block 011 (in 2nd Row)
[Go!]
Check fields 2, specification is ADP OK.

  • Move the selector lever in position D and drive with partial load 20 m / 70 ft forward, then brake to standstill.
  • Hold the brake for 10 seconds.
  • Move the selector lever in position R and drive with partial load 20 m / 70 ft reverse, then brake to standstill.
  • Hold the brake for 10 seconds.

The procedure needs to be repeated at least 5 times and can be repeated up to 10 times until the measuring values show ADP OK.
[Done, Go Back]
[Close Controller, Go Back - 06]