VW Passat (3C) Tire Pressure Monitoring

From Ross-Tech Wiki
Revision as of 11:06, 15 May 2012 by Dana (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Coding

2004 - 2009 Model Years

  • Rest of World (RoW):
    • 0161211 = Factory
    • 0161210 = Service (for manual input of specified pressure)
  • North America (NAR):
    • 0100101 = Factory
    • 0100100 = Service (for manual input of specified pressure)

2010 and newer vehicles equipped with the (BCM) 09-Cent. Elect. module have a different coding chart. These models include the Jetta, Golf, Tiguan and Eos and use Long Coding. The [Long Coding Helper] will provide the needed coding information if the original coding cannot be retrieved.


Note: When Replacing/Recoding a Control Module use the Service Coding and alter the Adaptation Channels afterward to their specified Values.


Security Access

  • 01503 - General Adaptation "Enabling"


Adaptation

Channel 002: Wheel Set

Wheel Set #1 and Wheel Set #2 may be altered without the Security Access. This channel default is 1.

  • Wheel set 2 would normally be winter or seasonal use wheels. Measuring Block 25 will show which "Reifen-Satz" is enabled.

Channel 005: Specified Tire Pressure at Full Load (Front Axle)

The specified tire pressure is being entered without a comma. So 2.4 bar is entered as 24.

Channel 006: Specified Tire Pressure at Partial Load (Front Axle)

The specified tire pressure is being entered without a comma. So 2.4 bar is entered as 24.

Channel 007: Specified Tire Pressure at Full Load (Rear Axle)

The specified tire pressure is being entered without a comma. So 2.4 bar is entered as 24.

Channel 008: Specified Tire Pressure at Partial Load (Rear Axle)

The specified tire pressure is being entered without a comma. So 2.4 bar is entered as 24.


Special Notes

The following Tech Tip will help explain this TPMS system: VW TPMS Systems without Wheel Position Recognition