Difference between revisions of "VW Transporter (7D) Brake Electronics (Bosch 5.3 ESP)"

From Ross-Tech Wiki
Line 1: Line 1:
 
__FORCETOC__
 
__FORCETOC__
== Login ==
+
== Login = =
  
 
'''''Note #1''': ''After Login has been carried out you need to recode the control module.''<br>
 
'''''Note #1''': ''After Login has been carried out you need to recode the control module.''<br>

Revision as of 15:25, 12 October 2010

= Login =

Note #1: After Login has been carried out you need to recode the control module.
Note #2: The PR codes ( such as 1LJ ) can be found in a sticker near the spare tire well. Click this link to see an example of a sticker PR-Codes.png

07669 US Market = (PR-1P4/1LB)

If your vehicle is not a US-market 24V VR6 Eurovan, then please email Support@Ross-Tech.com for additional choices.

Coding

Note #1: Coding is accepted after a specific login has been carried out.
Note #2: After successful coding the steering angle sensor basic setting needs to be carried out.
Note #3: The PR codes ( such as 1LJ ) can be found in a sticker near the spare tire well. Click this link to see an example of a sticker PR-Codes.png
Note #4: You may need to put a non-zero WSC in the Coding screen, anything should work such as 12345.

06639 US Market = (PR-1P4/1LB)

If your vehicle is not a US-market 24V VR6 Eurovan, then please email Support@Ross-Tech.com for additional choices.

Basic Setting

Steering Angle Sensor (G85) Calibration

Note: A successful calibration usually requires a correct coding, so make sure the control module is correctly coded first.

[Select]
[03 - ABS Brakes]

[Fault Codes - 02]
[Done, Go Back]

Turn steering wheel at least 30 ° left and back straight ahead.

[Meas. Blocks - 08]
Group 005 Field 1 (Steering Angle Sensor -G85-)
Specification: 0.0 °
Tolerance (when straight): ±5.0 °
[Done, Go Back]

[Login - 11]
Enter 40168
[Do It!]

[Basic Settings - 04]
Group 001
[Go!]
[Done, Go Back]

[Fault Codes - 02]
All fault codes should have disappeared.
[Done, Go Back]

[Close Controller, Go Back - 06]