00934: Difference between revisions
From Ross-Tech Wiki
Table Of Contents
RtWiKiSyS0p (talk | contribs) No edit summary |
No edit summary |
||
Line 12: | Line 12: | ||
* Automatic Run & Pinch Protection not adapted | * Automatic Run & Pinch Protection not adapted | ||
* Incorrect Window Motor / Door control module installed | |||
==== Possible Solutions ==== | ==== Possible Solutions ==== | ||
* Adapt Automatic Run & Pinch Protection (see Special Notes) | * Adapt Automatic Run & Pinch Protection (see Special Notes) | ||
* Verify the correct Window Motor(s) / Door control module(s) are installed | |||
==== Special Notes ==== | ==== Special Notes ==== |
Latest revision as of 14:26, 7 September 2012
00934 - Electric Window Motor; Rear Left (V26)
00934 - Electric Window Motor; Rear Left (V26): No or Incorrect Basic Setting / Adaptation
Possible Symptoms
- Window Automatic Run not working
- Pinch Protection limited
Possible Causes
- Automatic Run & Pinch Protection not adapted
- Incorrect Window Motor / Door control module installed
Possible Solutions
- Adapt Automatic Run & Pinch Protection (see Special Notes)
- Verify the correct Window Motor(s) / Door control module(s) are installed
Special Notes
- Pinch Protection Adaptation
- Make sure the window in question is completely closed.
- Use the driver door window buttons to operate the window(s).
- Roll down the window and keep holding the button down for 2 additional seconds after the window is already fully opened.
- Roll up the window and keep holding the button up for 2 additional seconds after the window is already fully closed.
- Now test the window automatic.