Difference between revisions of "00297"
From Ross-Tech Wiki
(Created page with '__FORCETOC__ == 00297 - Gearbox Speed Sensor (G38) == === 00297 - Gearbox Speed Sensor (G38): No Signal === ==== Possible Causes ==== * Wiring/Connectors faulty **Water damage…') |
|||
| Line 18: | Line 18: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | * | + | |
| + | * When found in the [[4-Speed Automatic Transmission (01M)]] transmission: | ||
| + | ** Check for any applicable TSBs for overlay wiring harnesses as mentioned on the 01M page. | ||
| + | ** The terminal connectors for the G38 and G68 are the same and can be mixed up. This can give an "Implausible Signal". Verify sensors have the correct connectors using the wiring diagram and TSBs mentioned on the 01M page. | ||
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 10:32, 4 January 2013
00297 - Gearbox Speed Sensor (G38)
00297 - Gearbox Speed Sensor (G38): No Signal
Possible Causes
- Wiring/Connectors faulty
- Water damage at connector
- Transmission Vehicle Speed Sensor (G38) faulty
Possible Solutions
- Check Wiring/Connectors
- Check Transmission Vehicle Speed Sensor (G38)
- See Measuring Value Blocks (MVB)
Special Notes
- When found in the 4-Speed Automatic Transmission (01M) transmission:
- Check for any applicable TSBs for overlay wiring harnesses as mentioned on the 01M page.
- The terminal connectors for the G38 and G68 are the same and can be mixed up. This can give an "Implausible Signal". Verify sensors have the correct connectors using the wiring diagram and TSBs mentioned on the 01M page.