Difference between revisions of "00778"
From Ross-Tech Wiki
Line 50: | Line 50: | ||
=== 00778 - Steering Angle Sensor (G85): No or Incorrect Basic Setting / Adaptation === | === 00778 - Steering Angle Sensor (G85): No or Incorrect Basic Setting / Adaptation === | ||
− | + | ||
==== Possible Causes ==== | ==== Possible Causes ==== | ||
Revision as of 13:03, 17 March 2016
00778 - Steering Angle Sensor (G85)
00778 - Steering Angle Sensor (G85)
Possible Causes
- Steering Angle Sensor (G85) Basic Setting lost
Possible Solutions
- Perform Steering Angle Sensor (G85) Basic Setting
- See Vehicle specific Diagnostic Procedures for Details
Special Notes
- This Fault Code may also be stored even though the Steering Angle Sensor (G85) is properly calibrated (Basic Setting), though it may not be finally initialized yet. Check the Measuring Value Blocks (MVB) in the Steering Aid Control Module (J500 / #44) for details. The Initialization will usually take place during a test drive.
00778 - Steering Angle Sensor (G85): Faulty
00778 - Steering Angle Sensor (G85): Defective
Possible Causes
- Steering Angle Sensor (G85) faulty
Possible Solutions
- Check Steering Angle Sensor (G85)
Special Notes
- With steering wheel level, wheels pointing straight ahead, make sure G85 is reporting 0 degrees +/- 5 degrees. If a reading of +360 or - 360 degrees is found. Remove steering wheel and turn clock spring 1 turn in direction needed to fix. See repair manual.
00778 - Steering Angle Sensor (G85): Implausible Signal
Possible Causes
- Steering Angle Sensor (G85) Basic Setting lost
- Steering Angle Sensor (G85) Installation Position incorrect
- No Communication between Steering Angle Sensor (G85) and Brake Electronics (J104)
Possible Solutions
- Perform Steering Angle Sensor (G85) Basic Setting
- See Vehicle specific Diagnostic Procedures for Details
- Check Steering Angle Sensor (G85) Installation Position
- Check communication between Steering Angle Sensor (G85) and Brake Electronics (J104)
00778 - Steering Angle Sensor (G85): No or Incorrect Basic Setting / Adaptation
Possible Causes
- Steering Angle Sensor (G85) Basic Setting lost
Possible Solutions
- Perform Steering Angle Sensor (G85) Basic Setting
- See Vehicle specific Diagnostic Procedures for Details
Special Notes
- When this DTC will not clear in Mk70 and MK60 ESP equipped (1K) Golf models see the WSS (Wheel Speed Sensor) notes Here.
00778 - Steering Angle Sensor (G85): Not Matched
Possible Causes
- Steering Angle Sensor (G85) Basic Setting lost
Possible Solutions
- Perform Steering Angle Sensor (G85) Basic Setting
- See Vehicle specific Diagnostic Procedures for Details
Special Notes
- When found in VW Golf/Jetta/Bora (1K/5M) or similar: Steering Assist:
- The Basic Setting differs depending on which ABS System is installed.
- For Vehicles with Brake Electronics (MK60) (see Component Identification) use these Instructions.
- For Vehicles with Brake Electronics (MK70) (see Component Identification) use these Instructions.
- The Basic Setting differs depending on which ABS System is installed.
00778 - Steering Angle Sensor (G85): Mechanical Failure
Possible Causes
- Steering Angle Sensor (G85) Basic Setting lost
- Steering Angle Sensor (G85) Installation Position incorrect
- Suspension Geometry incorrect
Possible Solutions
- Perform Steering Angle Sensor (G85) Basic Setting
- See Vehicle specific Diagnostic Procedures for Details
- Check Steering Angle Sensor (G85) Installation Position
- Check Suspension Geometry
00778 - Steering Angle Sensor (G85): No Signal/Communication
Possible Causes
- Steering Angle Sensor (G85) faulty
- Steering Angle Sensor (G85) configured incorrectly due to replacement control modules or incorrect coding
- Buggy ABS controller software
Possible Solutions
- Check Steering Angle Sensor (G85)
- Check Steering Angle Sensor (G85) location and configuration on the vehicle in question
- Check ABS controller software per TPIs, TSBs and recall publications .