Difference between revisions of "01044"

Revision as of 13:09, 1 April 2016

When found in CAN-Gateway:
- On a Long Coded module, use the Gateway Installation List to check for unreachable or not registered control modules. Then update the Gateway [Installation List] by altering the Gateway Coding manually.
- On a Short Coded modules, refresh the original coding with the same value. For example, code it from 00006 -to- 00006 without making an actual change.
When found in VW New Beetle/Cabriolet (1C/1Y/9C): Comfort System, this may be a Bug in the Control Module Software that will be resolved by refreshing the Coding with the same Value as described above with the CAN Gateway example.
When found in VW Passat (3C) Brake Electronics, VW Tiguan (5N) Brake Electronics and Brake Electronics (MK60EC1) when the 19-CAN Gateway Coding is NOT all Zeros, check the [19-CAN Gateway] > [Coding - 07]. An incorrect LHD/RHD Configuration may cause this Fault Code and may be stored in conjunction with 01299.
When found in the VW Passat (3B) Gateway Controller: Vehicles built through January 2000, the Gateway Software did not take in account for the ABS Controller. This fault code should be ignored. New Software was implemented after February 2000 that eliminated this fault code, however the coding should not be changed to add the ABS controller.

Some Passat (3B/B5) around MY 2000 have a Firmware Bug which causes this DTC to be set in the CAN Gateway (19). Service Documents for of those Cars indicate that this DTC should be ignored in that Module as long as the Coding matches the Vehicle Equipment.

Check/Fix Coding Pin/Bridge in Wiring
Check Control Module part numbers
Check/Fix Control Module Coding
- See Vehicle Specific Diagnostic Procedures for Details

@@ Line 22: / Line 22: @@
 ** On a [http://www.ross-tech.com/vcds/tour/recode_screen.html Short Coded] modules, refresh the original coding with the same value. For example, code it from 00006 -to- 00006 without making an actual change.
 * When found in [[VW New Beetle/Cabriolet (1C/1Y/9C)]]: Comfort System, this may be a Bug in the Control Module Software that will be resolved by refreshing the Coding with the same Value as described above with the CAN Gateway example.
-* When found in [[VW Golf (1K) Brake Electronics (MK60EC1)|Brake Electronics (MK60EC1)]] while the Coding is NOT all Zeros, check the '''[19-CAN Gateway]''' > '''[Coding - 07]'''.  An incorrect LHD/RHD Configuration may cause this Fault Code.
+* When found in [[VW Passat (3C) Brake Electronics]], [[VW Tiguan (5N) Brake Electronics]] and [[VW Golf (1K) Brake Electronics (MK60EC1)|Brake Electronics (MK60EC1)]] when the 19-CAN Gateway Coding is NOT all Zeros, check the '''[19-CAN Gateway]''' > '''[Coding - 07]'''.  An incorrect LHD/RHD Configuration may cause this Fault Code and may be stored in conjunction with [[01299]].
 *When found in the [[VW Passat (3B)]]  Gateway Controller: Vehicles built through January 2000, the Gateway Software did not take in account for the ABS Controller. This fault code should be ignored. New Software was implemented after February 2000 that eliminated this fault code, however the coding should not be changed to add the ABS controller.