VW Touareg (7L) Headlight Aim Control (Xenon with AFS)

From Ross-Tech Wiki
Revision as of 10:23, 15 March 2016 by Dana (talk | contribs) (Created page with "__FORCETOC__ == Coding == This control module supports conventional short coding. When VCDS is connected to the control module a coding chart should appear in a pop-up ball...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Coding

This control module supports conventional short coding. When VCDS is connected to the control module a coding chart should appear in a pop-up balloon.

When replacing the 55-Headlight Range control module the original factory coding should be used. If the original coding is not known each coding inquiry has to be configured per vehicle based on the complete Auto-Scan and vehicle repair history. Registered Customers can email directly.

Basic Setting

Headlight Adjustment

[Select]
[55 - Xenon Range]
[Basic Settings - 04]
Group 001
[Go!]
Activate the Basic Setting.
[ON/OFF/Next]

  • The meas. block field now shows "Wait" and should switch to "Adjust Headlights" then (this may take up to 10 seconds).
  • Adjust the headlights using their manual adjusting screws as referenced against a suitable aiming target.

[ON/OFF/Next]
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]

Retrieved from "http://wiki.ross-tech.com/wiki/index.php?title=VW_Touareg_(7L)_Headlight_Aim_Control_(Xenon_with_AFS)&oldid=7995"