Difference between revisions of "02914"
From Ross-Tech Wiki
(Created page with "__FORCETOC__ == 02914 - Sensor 1 for Trunk/Hatch Closed (G525) == === 02914 - Sensor 1 for Trunk/Hatch Closed (G525): Open or Short to Plus === ==== Possible Symptoms ==== ...") |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 21: | Line 21: | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
| − | * When found in the [[Audi Q5 (8R) | Audi Q5]] after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the [[Official Factory Repair Information | repair manual]] but the trim surrounding the striker for the rear hatch should contain both switches. | + | * When found in the [[Audi Q5 (8R) | Audi Q5]] or [[Audi Q7 (4L) | Audi Q7]] after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the [[Official Factory Repair Information | repair manual]] but the trim surrounding the striker for the rear hatch should contain both switches. |
** This fault is typically stored in conjunction with [[02915]] after trailer hitch retrofits and rear bumper repairs/removal. | ** This fault is typically stored in conjunction with [[02915]] after trailer hitch retrofits and rear bumper repairs/removal. | ||
| − | + | * When found in models such as the Audi A1 (8X) or Audi Q3 (8U/FS) with PQ35 BCM, make sure G525 is connected and properly installed. Measuring Block data is discussed [http://forums.ross-tech.com/showthread.php?14694-Wanted-Audi-A1-or-Q3-BCM-(PQ35)-Measuring-Block-Maps&p=132520&viewfull=1#post132520 Here] | |
[[Category:Fault Codes]] | [[Category:Fault Codes]] | ||
Latest revision as of 08:57, 25 June 2018
02914 - Sensor 1 for Trunk/Hatch Closed (G525)
02914 - Sensor 1 for Trunk/Hatch Closed (G525): Open or Short to Plus
Possible Symptoms
- Tailgate open warning active on dash
- Rear tailgate lamps not operating
Possible Causes
- Hatch Closed switch G525 unplugged or faulty
- Power or ground supply issue to Hatch Closed switch G525
Possible Solutions
- Confirm connection issues are not present
- Test/replace Hatch Closed switch G525
Special Notes
- When found in the Audi Q5 or Audi Q7 after repairs in the rear of the vehicle verify the G525 and G526 sensors are plugged in. These can be found in the repair manual but the trim surrounding the striker for the rear hatch should contain both switches.
- This fault is typically stored in conjunction with 02915 after trailer hitch retrofits and rear bumper repairs/removal.
- When found in models such as the Audi A1 (8X) or Audi Q3 (8U/FS) with PQ35 BCM, make sure G525 is connected and properly installed. Measuring Block data is discussed Here