Difference between revisions of "01739"
From Ross-Tech Wiki
| Line 16: | Line 16: | ||
* Check wiring and connections for G284 | * Check wiring and connections for G284 | ||
* If connections are ok, change passenger side crash sensor (G284) with drivers side sensor (G283). If the fault change also, you found a faulty sensor. Replace it | * If connections are ok, change passenger side crash sensor (G284) with drivers side sensor (G283). If the fault change also, you found a faulty sensor. Replace it | ||
| − | * If changing G283 with G284 does not change the fault, then check wiring between G284 and Airbag Control Unit | + | * If changing G283 with G284 does not change the fault, then check wiring between G284 and Airbag Control Unit. |
| + | ** If someone repaired or replaced the 2 wire connector at the crash sensor and reversed (swapped) the wiring the DTC may show: Open or Short to Plus - MIL ON. The wiring diagram for the vehicle in question will add clarity. | ||
==== Special Notes ==== | ==== Special Notes ==== | ||
Latest revision as of 09:49, 1 November 2018
01739 - Crash Sensor for Front Airbag: Passenger Side (G284)
Possible Symptoms
- Airbag Light is on
- MIL is on
Possible Causes
- Wiring and/or connections faulty
- G284 is faulty
Possible Solutions
- Check wiring and connections for G284
- If connections are ok, change passenger side crash sensor (G284) with drivers side sensor (G283). If the fault change also, you found a faulty sensor. Replace it
- If changing G283 with G284 does not change the fault, then check wiring between G284 and Airbag Control Unit.
- If someone repaired or replaced the 2 wire connector at the crash sensor and reversed (swapped) the wiring the DTC may show: Open or Short to Plus - MIL ON. The wiring diagram for the vehicle in question will add clarity.
Special Notes
- When found in the NAR (North American Region) New Beetle and New Beetle Convertible models see if the R6 / 69H1 Safety Recall was completed. The TSB involves replacing both crash sensors (G284 & G283) when the old / early production sensors are instated.
- The common fault codes are 01739 and / or 01738