Audi A4 (8E) Automatic Roof

From Ross-Tech Wiki
Revision as of 11:11, 4 May 2017 by Dana (talk | contribs)


Additional information can be found in the Official Factory Repair Information and sources such as Bentley Publisher's SSP (Self-Study Program) .


Adaptation

Channel 01: Reset

Prerequisites:

  • Automatic Roof closed
  • Measuring Value Blocks (MVB) OK

To reset the switch positions, save a new value of 1.

Special Notes

  • If Adaptation will not set with only the 02000 fault present, check TSB 61-08-05 (2010940, NAR only)
  • If fault code 00003 - Control Module: Defective -or- Control Module: No or Incorrect Basic Setting / Adaptation will not clear after replacing the 26 module try locking the vehicle doors so the CAN Bus modules go into sleep mode. Upon waking back up, the internal CAN Bus modules on the Comfort Bus may begin to communicate properly.

Measuring Block Data

Reading Roof Electronics Switch Conditions, Electric Power Top Closed

Measuring Block Group 001 (Roof Closed)
Field 2 X Field 3 Data
1 1 0 1 1 0 1 0 1 0 X 1 0 1 0 F201 Convertible top box lid, top switch
F290 Compartment Left Locked Switch
F293 Compartment lid lock switch, unlocked
F200 Convertible top box lid latched switch 1, right
X
Not used, always "0"
F292 Convertible top compartment tray position switch
X
F171 Convertible top open switch
F202 Convertible top closed switch
F294 Convertible top latch switch, open
F295 Convertible top latch switch, closed
F172 Convertible Top Front Lock Switch
Switch Point for Bow UP
Switch Point for Bow OPEN
Switch Point for Bow DEAD CENTER

Reading Roof Electronics Switch Conditions, Electric Power Top Opened

Measuring Block Group 001 (Roof Opened)
Field 2 X Field 3 Data
0 0 1 0 1 0 0 1 1 0 X 1 0 1 0 F201 Convertible top box lid, top switch
F290 Compartment Left Locked Switch
F293 Compartment lid lock switch, unlocked
F200 Convertible top box lid latched switch 1, right
X
Not used, always "0"
F292 Convertible top compartment tray position switch
X
F171 Convertible top open switch
F202 Convertible top closed switch
F294 Convertible top latch switch, open
F295 Convertible top latch switch, closed
F172 Convertible Top Front Lock Switch
Switch Point for Bow UP
Switch Point for Bow OPEN
Switch Point for Bow DEAD CENTER

Special Notes

  • If the top is inoperative and there are no fault codes, hold the Convertible Top Control Switch in the Open or Close position for 30 seconds, then check for fault codes. DTCs such as 03245 -or- 01093 may be stored.
  • Please see this thread for feedback related to DTC: 01995 - Convertible Top Lock Switch (F295)
  • Please see this thread for feedback related to DTC: 02023 - Terminal 87: Implausible signal

Video Link

A4 Top Operation

http://www.youtube.com/watch?v=Q_SumTD87lQ

  • Note that this video will be replaced with a more detailed A4 Cabriolet Top Operation video.