Difference between revisions of "Xenon Basic Settings in BCM1/09-Cent. Elect. (J519) controller"
| Line 19: | Line 19: | ||
* Vehicle on Level ground. | * Vehicle on Level ground. | ||
* Headlights, suspension leveling components and similar fully assembled and in proper working order. | * Headlights, suspension leveling components and similar fully assembled and in proper working order. | ||
| − | * Address 09-Cent. Elect (BCM1) fault free with the exception of [[01539]], [[02658]], and [[02659]]. | + | * Address 09-Cent. Elect (BCM1) fault free with the exception of [[01539]], [[02656]], [[02657]], [[02658]], and [[02659]]. |
* Headlight switch ON (not Auto''matic'' mode): | * Headlight switch ON (not Auto''matic'' mode): | ||
Revision as of 13:11, 22 September 2016
General Information
This page applies to vehicles with factory installed Xenon headlights that do NOT use a diagnostic capable 55-Headlight Range control module. If the vehicle in question has a diagnostic capable 55-Headlight Range control module please use the applicable Ross-Tech Wiki Diagnostic Procedure page for that system.
- Registered VCDS users encountering difficulty determining which type of factory installed Xenon headlight system is installed can:
- Join and post the complete VCDS Auto-Scan in the Car Repair Support section of our forum.
- Send the complete VCDS Auto-Scan directly via email.
- Registered VCDS users encountering difficulty Retrofitting a Xenon headlight system need to join and post in the Retrofits section of our forum. Post the Auto-Scan prior to the retrofit in addition to the Auto-Scan after the replacement parts were installed when assistance is needed.
As of VCDS Release 15.7.0 it is possible to perform Basic Settings in address 09-Cent. Elect. This procedure has received limited feedback to date so Paul's New Xenon Range Adjustment Procedure - HOW TO thread may be helpful.
Basic Setting
Headlight Adjustment
Prerequisites:
- Vehicle on Level ground.
- Headlights, suspension leveling components and similar fully assembled and in proper working order.
- Address 09-Cent. Elect (BCM1) fault free with the exception of 01539, 02656, 02657, 02658, and 02659.
- Headlight switch ON (not Automatic mode):
[Select]
[09 - Cent. Elect.]
[Basic Settings - 04]
Group 011
[Go!]
- The meas. block field shows [Reg. Position | Learned | 0.0 | N/A]
Activate the Basic Setting.
[ON/OFF/Next]
- The meas. block field now shows [Adjust | Headlights | not available | N/A]
- Adjust the headlights (if needed) using their manual adjusting screws as referenced against a suitable aiming target.
Deactivate the Basic Setting.
[ON/OFF/Next]
- The final meas. block field shows [Reg. Position | Learned | 0.0 | N/A] again.
The adjustment should now be learned.
[Done, Go Back]
Don't forget to check/clear fault codes afterwards.
[Close Controller, Go Back - 06]